Counter flashing....

Arrrrrr, ahoy ther swabs, an ye also ther Big R, well shiver me timberlines therr we says for shure. In all me sailin of tha Seven Subds , we never thought we wood come to tha day that we wood as this, as much as it hurts , Ole jack must say that he concu>>>

[quote]Another simpler way is to just use a termination bar counter/flashing. It looks about the same, except you bend the flashing out at the top about half an inch at a 45 degree angle.

That certainly would NOT pass an inspection anywhere I hav>>>

one more thing, install vapor barrier at the highest point under the new counter...helps prevent condensation issues>>>

Used a tile saw to cut straight line around the chimney, lots of brick dust and makes a dirty mess on a brand new roof...make the cuts on the t/off phase

Remove excess loose mortar and blow out with an air gun. If there has been a lot of moisture over t>>>

Hi,

Same here. All three ways work.

Do it the way the customer wants it to look.>>>

That will work just fine. If you di it that way, just make sure and bned the top of the metal that you insert into the cut joint with about an 1/4 inch reverse bend as far as the break will bend it. When you drive it into the reglet it will bite like a>>>